ADS Riser Installation

Step 1:

Cut pipe on top of rib using a jigsaw, hand saw, or circular saw

Step 2:

Slide Riser into pipe. Then drill four equally spaced 5/16″ holes around the bottom of the riser/pipe connection and two across the top. Then insert carriage bolts with washer and nut and tighten.

Finished Product

When installing flashboard risers make sure to cover the risers with dirt completely and all the way up to the back as shown here. ┬áNot Illustrated: drive rebar anchors (included) to maximum depth to ensure riser stays in place and doesn’t float up.

Some examples of installed risers